Seenergy SVR- 632 User Manual page 224

224 SVR-­‐632 U ser's M anual
The UPS information should be obtained and displayed at the bottom
of the page after the settings are applied:
To enable network UPS support (NVR acting as UPS
slave):
1. Go to "NVR Setup" >> "UPS Configurations", and check "Enable UPS
Support" option.
2. Enter the IP address of the NVR running as UPS server. (The
NVR with USB UPS physically attached to)
* Please make sure both NVRs (UPS server and slave) are on the same
local network to ensure the communication between the two.
* Please make sure both NVRs are plugged into the outlets that
connect to the UPS.