Table of Contents
Advertisement
WARNING! Do not operate the appliance if it is
damaged or has malfunctioned. If you suspect
the appliance is damaged or has malfunctioned
call a qualified service engineer to inspect the
appliance, and replace any part of the electrical
system if necessary, before reuse.
Do not disconnect the power at the main supply while
the appliance is running. Use the functions on the remote
to turn the fire off and ensure the main switch has been
moved to the off position before disconnecting.
MANUAL CONTROL PANEL
4
1
2
1. Flame On/Off and heater Off
2. Flame On/Off button
3. Heater On/Off
4. Remote Reset Button
5. Heater running indictators
Note: To deactivate the beeping/audible sound, press and hold in
the FLAME button on the manual control panel for 3 seconds.
To reactive the beeping, repeat same steps.
OPERATING THE APPLIANCE
Press 1 to turn the appliance on/off.
Press 2 to turn flames on/off.
Press 3 to turn the heater on/off in boost mode.
IMPORTANT: If operating the appliance using the
remote
control provided, do not touch the following
buttons on the control panel. (1. Flame On/Off and
heater Off 2. Flame On/Off button 3. Heater On/Off)
These 3 buttons on the control panel are only to be used
when operating the appliance in manual mode without
use of the remote control.
6
OPERATING INSTRUCTIONS
5
3
Owner's Information
REMOTE CONTROL
The remote control should be left on a flat surface in the
room where the appliance is installed and away from any
direct flow of hot air.
- Power On/Off
Heater
-
- Flames
- Fuel Bed
- Timer
- Colour option
Levels
-
OPERATING THE APPLIANCE
- QUICK START
Turn the Appliance On/Off
The appliance will start on the last remembered setting.
Turn the Heater On/Off.
- Increase or decrease the heat output.
Turn the Flame Effect On/Off.
- Increase or decrease the brightness level.
Turn the Fuel Bed Effect On/Off.
- Change the colour option.
There are fourteen fuel bed colour options:
- Increase or decrease the brightness level.
- Set a Timer
Press the button to set the timer. The Timer can be set at 0.5H,
1.0H, and then each hour up to 10.0H.
Advertisement
Table of Contents
