Table of Contents
Advertisement
FM/AM
PTY+
\ \
\ \
\
DISPLAY
PTY
MODE
SEARCH
PTY–
Remote control
Searching for a Program by PTY Codes
PTY SEARCH
PTY SEARCH
Front panel
Page 23
When pressing DISPLAY MODE on the remote control:
Make sure that you have selected FM station using the remote control only.
If not, the DISPLAY MODE button does not work for tuner operation. (Pressing FM/AM activates the remote
control for tuner operation.)
Notes:
• If searching finishes at once, "PS", "PTY", and "RT" will not appear on the display.
• If you press DISPLAY MODE while listening to an AM (MW/LW) station, the display only shows station
frequency.
• RDS is not available for AM (MW/LW) broadcasts.
One of the advantages of the RDS service is that you can locate a particular kind of program from the preset
channels by specifying the PTY codes.
To search for a program using the PTY codes
On the front panel:
1. Press PTY SEARCH while listening to an FM station so that Control @ @ @ @ @ / # # # # # buttons work for
selecting PTY code.
"PTY" and "SELECT" alternate on the display.
2. Press Control @ @ @ @ @ / # # # # # until the PTY code you want appears on the display.
Each time you press the button, the display gives you the PTY codes described on page 24.
3. Press PTY SEARCH again.
While searching, "SEARCH" and the selected PTY code alternate on the display.
The receiver searches 40 preset channels, stops when it finds the one you have selected, and tunes in
that station.
To continue searching after the first stop
Press PTY SEARCH again while the indications on the display are flashing.
If no program is found, "NOTFOUND" appears on the display.
To stop searching any time during the process
Press PTY SEARCH while searching.
Advertisement
Table of Contents
