JVC RM-SR630RU Instructions Manual page 38

ON/OFF
MODE
DELAY
REAR
CENTER
Remote Control
Page 33
From the remote control:
Note:
You cannot adjust the center mode and the center tone using the remote control.
1. Press ON/OFF so that the SURROUND indicator lights up on the display.
The previous surround mode is recalled (at its previous settings) and is shown on the display.
Each time you press the button, the surround mode turns on and off.
2. Press MODE until "PROLOGIC" or "3CHLOGIC" whichever you want appears on the
display.
Each time you press the button, the surround modes change as follows (the indicator of the selected
surround mode also lights up on the display):
PROLOGIC
3. Press DELAY to adjust the delay time of the rear speaker output.
Each time you press the button, the delay time changes as follows:
DELAY 1
DELAY 4
Note:
When you have selected "3CHLOGIC," you cannot adjust the delay time.
4. Press TEST to start checking the speaker output balance.
"TEST" starts flashing on the display, and a test tone comes out of the speakers in the following
order:
Left front speaker
Notes:
• No test tone comes out of the rear speakers when you have selected "3CHLOGIC."
• No test tone comes out of the center speaker when you select "PHANTOM" or "OFF" for the center
mode.
5. If necessary, adjust the speaker output level as follows:
• To adjust the rear speaker output level, press REAR +/–.
• To adjust the center speaker output level, press CENTER +/–.
Pressing – decreases the output level up to –10 dB.
Pressing + increases the output level up to +10 dB.
Notes:
• You cannot adjust the left and right rear speaker output level separately.
• You cannot adjust the rear speaker output level when you have selected "3CHLOGIC."
• You cannot adjust the center speaker output level when you select "PHANTOM" or "OFF" for the
center mode.
6. Press TEST again to stop the test tone.
3CHLOGIC
SURR OFF
(Surround Off)
DELAY 2
DELAY 3
Center speaker
Rear speakers
HALL
Right front speaker