Connecting The Controller (Bkm-16R); Connecting The Multiple Units With The Lan - Sony Trimaster BVM-L231 Operation Manual

Connecting the Controller (BKM-
16R)
Monitor
PEER TO
PEER
NETWORK
LAN
Set to PEER TO
PEER.
LAN (10/100) connector
SMF-700, etc.
DC 5V/12V IN
connector
Controller
(BKM-16R)
NETWORK
LAN
PEER TO PEER
Set to PEER TO PEER.
1
Turn off the MAIN POWER switch of the monitor
before connecting the units.
2
Set the NETWORK switches of the monitor and the
controller to PEER TO PEER.
3
Connect the LAN (10/100) connector of the monitor
and the LAN (10/100) connector of the controller by
using the SMF-700 or the cable supplied with the
BKM-37H, or a 10BASE-T/100BASE-TX straight
LAN cable (shielded-type, optional).
Note
When an optional LAN cable is connected, use a
shielded-type cable to prevent a malfunction due to
noises.
4
Connect the DC 5V OUT connector of the monitor and
the DC 5V/12V IN connector of the controller by using
the SMF-700 or the cable supplied with the BKM-37H.
Connecting the Multiple Units with
the LAN
DC 5V OUT
connector
The controller controls up to 32 monitors. Up to four
controllers are connected to one monitor in single mode.
Note
The controller cannot control monitors in another
subnetwork.
LAN (10/100)
connector
Or connect the output cable of the AC adaptor supplied
with the controller to the DC 5V/12V IN connector of
the controller.
23
Connections