Sony Trimaster BVM-L231 Operation Manual page 59

Menu
Gamma
Copy From
Preset Value
Other Monitor
Monitor ID
Memory Stick
User LUT
Load LUT
Delete LUT
Function and operation ([
Sets the transmission gamma.
[2.2]: Transmission gamma 2.2
2.6 RGB: Transmission gamma 2.6 for the RGB format
2.6 XYZ: Transmission gamma 2.6 for the XYZ format
xvYCC: Transmission gamma of IEC 61966-2-4 standards (xvYCC)
S-LOG Standard: Log gamma available with the F23 Digital Cinematography Camera.
Select to run the 100% output level of the F23 with the 100% level of the monitor for
confirmation.
S-LOG Full: Log gamma available with the F23.
Select to fit the full dynamic range of the F23 in the 100% level of the monitor for
confirmation.
Notes
• As 2.6 RGB is setting for 2048 × 1080 RGB format, the input signal of any other format is
not displayed correctly.
• When you select xvYCC, set Emulation (page 55) to L231 Native in the Color Gamut menu
of the Input Configuration menu to display the extended color gamut area.
• When the quantization range of the DVI signal or HDMI signal is Full, the internal fixed
value of the transmission gamma is applied.
Copies the user data from the other Matrix/Gamma.
Copies other data in this monitor.
When the item is selected, you can select from User1, User2, User3, User4 or User5.
Copies data from another monitor.
Enter the ID number of the source monitor.
When the NETWORK switch is set to PEER TO PEER, this is not selectable.
When the ID number is entered, you can select from User1, User2, User3, User4 or User5.
Copies data in the "Memory Stick".
When the item is selected, the file names in the source "Memory Stick" are displayed.
When the file is selected, you can select from User1, User2, User3, User4 or User5.
Sets the user data (User1 to User5) of Color Gamut.
Reads a LUT data file from a "Memory Stick".
You can select from User1, User2, User3, User4 or User5.
When a LUT data file is read for the user data (User1 to User5), the file name is displayed
next to the user data.
When you select the user data, a list of LUT data files in the "Memory Stick" is displayed, and
you can select a file name.
Notes
• Use the controller with software version 1.3 or higher to load the LUT data file from the
"Memory Stick".
• After converting the LUT data output from Grading Tool of another vendor to LUT data in
the Sony-unique format, convert the LUT data again with the coversion tool so that it can
be read by the monitor.
To obtain the Sony-unique format specifications for the LUT data to input to the conversion
tool, conversion tool and operation procedures for the conversion tool, contact your Sony
representative.
Deletes the LUT data file read into the user data (User1 to User5).
Note
When there are no user data with the LUT data file, you cannot select the user data.
When the item is selected, the user data with the LUT data file, file name and All are
displayed.
When a user data is selected to delete each user data (file) or All is selected to delete all user
data, the following message is displayed:
Delete this data?
OK: To delete the data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
]: factory setting)
59
Display Setting Menu