Table of Contents
Advertisement
MegaRAID SAS 9285-8e RAID Controller Quick Installation Guide
|
LSI Corporation
December 2010
The CD contains utility programs, device drivers for various operating systems, and
the following documentation:
— MegaRAID 6Gb/s SAS RAID Controllers User Guide
— MegaRAID SAS Software User Guide
— MegaRAID SAS Device Driver Installation User's Guide
— Cache Backup Products for MegaRAID SAS RAID Controllers User Guide
— MegaRAID LSIiBBU09 Intelligent Battery Backup Unit Quick Installation
Guide
— Software license agreement
2. Prepare the Computer
Turn off the computer, and unplug the power cords from the rear of the power
supply. Remove the cover from the computer.
Before you install the RAID controller, make sure that the computer is
!
disconnected from the power and from any networks.
CAUTION
3. Review the Jumpers and the Connectors
Figure 2
shows the location of the jumpers and the connectors on the RAID
controller. The jumpers are set at the factory, and you usually do not need to change
them.
Controller Installation
Page 5
Advertisement
Table of Contents
