Advertisement
3-3 Open The Box
This Equipment is suitable for use in IP65 / IP66 with dust and water protection, and its robust and
fanless design for reliable operation. For the seamless products we adopt the stainless steel
housing is all made of aluminum material with deactivated coating for outside chassis, this is to
prevent the oxidization.
For inside electronic parts are adopted with passive cooling , fanless design, certain models with
highly powerful MCUs are with aluminum heatsink conducting heat to the back cover of housing.
The whole sealing of chassis is with gasket surrounded underneath the opening doors, all screws
are operated with screw glue to secure the IP proof.
Connectors are all special IP level instead of normal connectors, please check the accessory box
before to operate the machine.
LCD Touch Screen Options
We also provide 2 different type of touch options, one is Projected capacitive multi-touch, the
other is 5-wire resistive single touch.
In the accessory BOX, please check all IP proof cables / connectors
1.Power Cord:
Connect the power cord to the AC outlet, and connect the IP66 power connector to the machine.
*If the unit is DC Input, the power cable will be attached with an AC/DC power adapter as below,
2.USB Signal cable connection (For monitors with touch option):
One USB cable for touch controller. One side is normal USB Type A male plug, the other side is IP66
connector to the machine.
3. Signal cable:
D-Sub 15 pin for a VGA signal. (DVI-D IP65 cable if there is with DVI input)
RS232 cable
Ethernet cable x2
15
Advertisement
