Siemens SIMATIC IPC BX-32A Operating Instructions Manual page 57

3. Secure the M.2 module with the screw
If the M.2 module includes a cable with an additional interface card that must be connected
to the enclosure opening, you must also execute the following steps:
4. Loosen the marked screws for fixing the
5. Place the additional interface card from
6. Connect the cable of the interface card
7. Close the device as specified in section "Opening the Device (Page 48)" or "Open device
Procedure - Removal
Proceed in reverse order of installation.
Configuring BIOS setup
You may need to make settings in the BIOS Setup. For detailed information about installation,
please refer to the documentation provided with the specific expansion module.
See also
Replacing M.2 NVMe SSD (Page 60)
SIMATIC IPC BX-32A
Operating Instructions, 09/2023, A5E52798407-AB
that you removed in the first step.
Only use the original screws with the
spacers.
Note: Make sure that the M.2 module is
between the head and the spacer of the
screw.
blanking cover using the Torx T10
screwdriver.
the inside against the empty enclosure
opening and secure it using the screw.
to the M.2 module.
with expansion slots (Page 50)".
Expanding and assigning parameters to the device
6.4 Expansion modules (M.2)
57