Table of Contents
Advertisement
Device version
Figure 6-1
Requirements
• You are familiar with the information on expansion cards and the conditions of use of
expansion cards, see "Usable expansion cards (Page 52)".
• The device is open, see important information regarding this under "Open device with
expansion slots (Page 50)".
• If the PCIe card to be used has external interfaces, you can use the built-in slot plates to
install the plug-in connectors. You can also use a slot plate with connector perforations.
• Screwdriver of type Torx T10
Procedure - Installation
1. Remove the screw (1) in the blanking
plate for the slot you require and remove
the blanking plate.
2. Remove the retainer (2).
3. Insert the expansion card into the slot on
the bus board (3).
Secure the expansion card with the corre-
sponding screw.
SIMATIC IPC BX-32A
Operating Instructions, 09/2023, A5E52798407-AB
Device version with one PCIe slot
Expanding and assigning parameters to the device
6.3 Expansion cards
53
Advertisement
Table of Contents
