Bellfires UNICA-2 40 Instructions For Use & Manual Daily Maintenance page 27

Bellfi res
Faults
• If the signals from the hand-held transmitter do not seem to be reaching the receiver,
the cause may be:
* Spent batteries: replace the batteries.
* An electronic problem: press the "RESET" button on the receiver.
• If the appliance regularly switches itself off, please contact your installer.
Replacing the batteries
• If the batteries are inserted incorrectly, the electronics or drive may be irreparably
damaged.
• Only replace the batteries when the appliance has been completely switched off.
Standard appliance:
• The hand-held transmitter/receiver batteries have a service life of approx. one year.
We recommend you use alkaline batteries.
Rechargeable batteries are not permitted.
• If the receiver's batteries are nearly empty, the system will turn the appliance off
completely. This will not occur if the receiver is connected to an AC power adaptor
(6V) (option).
• The batteries must be replaced whenever:
1 Hand-held transmitter : The battery symbol indicates this in the display.
2 Receiver: 3 seconds: short beeps, audible when the motor-knob operates.
1 Hand-held transmitter:
* Open the cover on the back of the transmitter.
* Remove the batteries from the battery compartment.
* Place two new 1.5V batteries (LR03 or AAA type) as indicated in the battery
compartment.
* Close the cover.
2 Receiver:
* Carefully pull the receiver assembly out of the compartment, behind the facade
of the appliance.
* Open the cover.
* Remove the batteries from the battery compartment.
* Place four new 1.5V batteries (LR06 or AA type) as indicated in the battery
compartment. The negative end (-) of the battery must always be at the contact
spring end of the compartment.
* Close the cover and place the receiver back in its holder.
Instructions for use
: Battery fully charged
English
: Battery empty
27