Bellfires UNICA-2 40 Instructions For Use & Manual Daily Maintenance page 11

Bellfi res
2.3.1 General
Read these instructions carefully before lighting the fi re !!
The appliance is opperated by radio remote control.
This comprises a hand-held transmitter and a receiver. The receiver is part of the gas
control block assembly.
The receiver and the gas control block are under in the appliance.
Electrical connections and batteries:
Standard appliance:
Hand-held
transmitter
Receiver
The appliance is supplied with ambient lighting:
Hand-held
transmitter
Receiver
Module - Light
*) During a power outage, you can temporarily install batteries in the receiver so that
the appliance continues to operate.
Note: Hand-held transmitter and receiver are not interchangeable with previous models.
The pilot light is situated in the front of the burner, behind a cowl. Should the pilot light
go out, you must wait fi ve (5) minutes before attempting to re-ignite the fi re.
Important
Once the fi re is lit, it must burn at maximum for approx. 10 minutes to allow the chimney
to come up to temperature!
Instructions for use
2x 1.5V battery
Type LR03 or AAA
4x 1.5V battery
Type LR06 or AA
2x 1.5V batterij
Type LR03 or AAA
6VDC
via the 5 wire cable
from the Light-Module
230 VAC
Option:
6VDC adapter (230VAC).
Available from your fi tter.
Note: Remove batteries from receiver!
Note:
No batteries in the
receiver. *)
English
11