Bellfires UNICA-2 40 Instructions For Use & Manual Daily Maintenance page 15

Gas fire with open combustion system

Hide thumbs Also See for UNICA-2 40:

Bellﬁ res

IMPORTANT: SETTING UP SIGNAL CODE BEFORE USING THE APPLIANCE

FOR THE FIRST TIME

Before the appliance can be used, the receiver must ﬁ rst learn the hand-held

transmitter's signal code.

• Press the "RESET" button on the receiver, and keep this pressed until 2 beeps are

heard. See ﬁ gure 4.

Release the "RESET" button after the second (somewhat longer) beep.

• Press, within 20 seconds, the

until 2 short beeps are heard. The signal code has now been set up on the receiver.

If, however, a single long beep is heard, this means that setting the signal code

has failed or that the wiring has been connected incorrectly.

You only need to set up the signal code once. It is not necessary when changing the

batteries of the hand-held transmitter or receiver.

Figure 4:

Receiver "RESET"

Instructions for use

button (small ﬂ ame) on the hand-held transmitter,

button

English

Table of Contents