Bellfires UNICA-2 40 Instructions For Use & Manual Daily Maintenance page 16

Bellfi res
2.3.3 Operation (Remote control)
MANUAL MODE (HAND-HELD TRANSMITTER)
SWITCH ON THE APPLIANCE / IGNITING THE FIRE
• Open the gas supply valve in the gas pipe to the fi re.
Warning
When the pilot light is ignited, the motor turns
automatically to maximum fl ame height.
AM
PM
ON
OFF
1 2
Note
Change from one-button to two-button ignition operation by pressing
and holding
ON is displayed and 1 is fl ashing. When change is complete 1 will
change to 2.
16
Hand-Held Transmitter One-Button Operation
(Default Setting)
• Press
blinking series of lines confi rms the start
sequence has begun; release button.
• Main gas fl ows once pilot ignition is confi rmed.
• Hand-held transmitter automatically goes into
Manual Mode after main burner ignition.
button for 10 sec. immediately after installing batteries.
button until two short beeps and a
English
Instructions for use