Fault Code; Electrical Connection; After Sales Service - Hisense HWFL1014V Quick User Manual

TRANSPORT/HANDING
C. Fault code
The washer stops when the program is running. The display window shows
fault code "F13", "F14", "F24", else fault codes from "F04" to "F98" or "Unb".
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door
(PTC) to check whether the door is closed.
Open or close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "F14" is shown
Door open fault.
Action: Press "Start/Pause" button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, press the "On/Off"

ELECTRICAL CONNECTION

button to restart the washing machine, and the alarm will be removed.
If fault code "F24" is shown
Water level reaches overflow level.
adequate for the machine's 10 A Current Rating.
Remove it by pressing "Start/Pause" key and feed water.
Select and start required program. If fault occurs again, disconnect power supply
The electrical power cable must be replaced exclusively by a licensed electrician.
and contact with after-sale service.
If else fault code "F04" to "F98" is shown
Electronic module fails.
Press "Power Supply" key for 3 sec to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "Unb" is shown
Unbalance alarm.
Press "Power Supply" key for 3 sec to turn off the machine. Open the door and re-
tidy clothes and then rotate program knob to single dehydration mode. Spin
clothes to dry again.
If fault occurs again, disconnect power supply and contact with after-sale service .
AFTER-SALES SERVICE
18 19