Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Hisense Washing Machines
Summary of Contents for Hisense Washing Machines
-
Page 3: Before Using
Dual inlet - and cold The minimum permissible inlet water pressure 0.1MPa if this is necessary for the correct operation of the appliance For washing machines with ventilation openings in the base that a carpet must not obstruct the openings. - Page 4 that that The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
-
Page 5: Preparation Of The Washing
Clean the outside of the washing machine with a damp cloth. Do not use abrasive BEFORE THE FIRST WASH CYCLE detergents. To remove any residual water used during testing by the manufacture r, we Never open the door forcibly or use it as a step. recommend that you carry out a short wash cycle without laundry. -
Page 6: Detergents And Additives
/ soak... -
Page 7: Draining Residual Water
Depending on the model, remove the plinth by holding it tightly on both sides, pushing it downward and tilting it to the front. Or, push down on the tabs provided on both the sides and remove it. unds... -
Page 9: Troubleshooting
solv and the power switched remove some... -
Page 10: Hot/Cold Fill Fault
Hot / Cold fill fault - For Models with Dual Inlets Fault Code List If you wish to connect hot and cold water supply (Fig.1): 1. Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red Displayed on Display Window Fault Description filter on the rear side of machine. -
Page 11: Fault Code
C. Fault code The washer stops when the program is running. The display window shows fault code from “F04’ to “F07”, “F13”, “F23” or “UNB”. If fault code “F24” is shown Water level reaches overflow level. Remove it by pressing “Start/Pause” key and feed water. Select and start required program.
Need help?
Do you have a question about the Washing Machines and is the answer not in the manual?
Questions and answers
my washing machine is on a dry cycle but is bleeping while still 1:20 mins left of the programme
The provided context does not mention a specific reason for a Hisense washing machine beeping during the dry cycle with 1:20 minutes left. However, beeping sounds in Hisense washing machines can indicate alerts such as unbalance alarms, drainage faults, or electronic module issues. You may check for error codes on the display or try turning off the beeping sound by holding the designated buttons for about 3 seconds until "Beep off" appears on the display.
This answer is automatically generated