Fault Code - Hisense 3 Series User's Operation Manual

C. Fault code
The washer stops when the program is running. The display window shows
fault code "F13", "F14", "F24", else fault codes from "F04" to "F98" or "Unb".
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door
(PTC) to check whether the door is closed.
Open or close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "F14" is shown
Door open fault.
Action: Press "Start/Pause" button. The washing machine will try to open the door.
The alarm will not be removed until the door is unlocked. Or, turn the nub to Off for 3
seconds to turn off the machine. Choose the desired programmme to start the
machine. The alarm will be removed.
If fault code "F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" key and feed water.
Select and start required program. If fault occurs again, disconnect power supply
and contact with after-sale service.
If else fault code "F04" to "F98" is shown
Electronic module fails.
Turn the nub to Off for 3 seconds to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
nb" is shown
Unbalance alarm shall be solved by the following methods
1.Laundry winding
Turn the knob to "off" for 3 seconds for shutdown, open the door, shake the clothes and
put them back into the washing machine, then select the single dewatering program to
dry again.
2.Too light-weighted laundry
Turn the knob to "off" for 3 seconds for shutdown, open the door, put in one or two
towels, and then select the single dewatering program to dry again.
18