Fault Code - Hisense WFHV6012 User's Operation Manual

C. Fault code
The washer stops when the program is running. The display window
shows fault code "F02/F24", fault codes from "F04' to "F07", "F13","F14",
"F23" or "Unb".
If fault code "F02/F24" is shown
Water level reaches overflow level.
Remove it by pressing "Start/Pause" key and feed water.
Select and start required program. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code "F04" to "F07", "F23" shown
Electronic module fails.
Turn the nub to Off for 3 seconds to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "F13" is shown
Door lock is abnormal. Start program for 20 sec and unlock the washer door
(PTC) to check whether the door is closed.
Open and close it again.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect
power supply and contact with after-sale service.
If fault code "F14" is shown
Door open fault..
Action: Press "Start/Pause" button. The washing machine will try to open the
door. The alarm will not be removed until the door is unlocked. Or, turn the nub to
Off for 3 seconds to turn off the machine. Choose the desired programmme to
start the machine. The alarm will be removed.
If fault code "Unb" is shown
Unbalance alarm.
Turn the nub to Off for 3 seconds to turn off the machine. Open the door and
re-tidy clothes and then rotate program knob to single dehydration mode. Spin
clothes to dry again.
If fault occurs again, disconnect power supply and contact with after-sale service.
18
adequate for the machine's 10 A Current Rating.
The electrical power cable must be replaced exclusively by a licensed electrician.
19