Fault Code - Hisense WH8014V User's Operation Manual

Hot / Cold fill fault - For Models with Dual Inlets
If you wish to connect hot and cold water supply (Fig.1):
1 Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red
filter on the rear side of machine.
2 Fix the other inlet hose to the cold water tap and to the inlet valve with the blue
filter on the rear side of the machine.
Make sure:
a) The connections are tightly fixed
b) Do not invert their position (for example: cold fill into hot inlet valve and vice versa).
If you wish to connect only the cold fill follow the below instructions (Fig. 2):
1 You will need a Y-piece connector. This can be purchased from local hardware or
plumbing supplier.
2 Fix the Y-piece connector to the cold fill tap.
3 Connect the two inlet valves present on the rear part of the machine to the Y-piece
connector using the hoses provided.
For Models with Single Inlet
Fix the inlet hose to the cold water tap and to the inlet valve on the rear side of the
machine as (Fig. 3).
Ensure that:
All connections are tightly fixed.
Do not allow children to operate, crawl on, be near or inside your washer.
Note that during the wash cycles, the surface temperature of the porthole door
may increase.
Close supervision of children is necessary when the appliance is used near
children.
Hot fill Cold fill
Red inlet valve
Blue inlet
valve
Fig.1
16
Cold fill
Y- piece
Red inlet valve
Inlet valve
Blue inlet
valve
Fig.2
Fig.3

Fault code

The washer stops when the program is running. The display window shows
fault code "F01"，"F03", "F13"，"F14", "F24", else fault codes from "F04" to "F98"
or "Unb".
Displayed on Display Window
"F01"
"F03"
"F13"
"F14"
"F24"
else fault code, "F04-F98"
"Unb"
"F01" displayed on screen
The machine is not fed with water or insufficient water. Check:
Faucet is fully open and has enough water pressure.
Water inlet pipe is knotted or not.
Filtering net of water inlet pipe is blocked or not (refer to maintenance and
repair).
Water pipe is frozen or not.
Press "Start/Pause" key after fault is removed.
If fault occurs again, please contact with after-sale service (refer to after-sale
Cold fill
service.).
"F03" displayed on screen
The washer is not emptied. The washer stops the program being executed. Shut
down the machine and disconnect power supply. Check:
Drain pipe is knotted or not.
Filter in drain pump is blocked or not (refer to the cleaning of filter in drain pump)
Ensure that
Fault Code List
Fault Description
Water inflow fault
Drainage fault
Door lock fault
Door unlock fault
Overflow or too much foam.
Electronic module fault.
Unbalance alarm
17