JETWAY 630BF User Manual page 20

5. Parallel Printer Connector (26-pin Block): PRINT
Connection for the enclosed parallel port ribbon cable with mounting bracket.
Connect the ribbon cable to this connection and mount the bracket to the case on
an open slot. It will then be available for a parallel printer cable.
NOTE: Serial printers must be connected to the serial port. You can enable the
parallel port and choose the IRQ through BIOS Setup.
6. Serial port COMA and COMB Connector (Two 10-pin blocks): COM1, COM2
These connectors support the provided serial port ribbon cables with mounting
bracket. Connect the ribbon cables to these connectors and mount the bracket to
the case on an open slot. The two serial ports on the mounting bracket will then be
used for pointing devices or other serial devices. See BIOS configuration of
"Onboard Serial Port"
7. Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy
drives.
17