Capacitance Measurement - East Tester ET3260 User Manual

Users manual
difference between actual measurement value and current recorded value.
5) Press the softkey of Display (
interface for details.
6) If necessary, press
and refer to the chapter of Measurement configuration for details.
7) If necessary, press
to description in the chapter of Math operation for details.

2.1.8 Capacitance measurement

Basic information
Measurement range: 1nF, 10nF, 100nF, 1uF, 10uF, 100uF, 1mF, 10mF and 100mF.

Maximum resolution: 10pF.

Operation description
1) Press to select capacitance measurement function.
2)
Description: Major displayed value refers to measurement capacitance value, and auxiliary
displayed value refers to the ratio between the measurement value and full measurement range.
3) Connect test lines as indicated in the chapter of 1.4 Measurement wiring.
4) Select measurement range as required, and may select automatic measurement, or press the
softkeys of Measurement range+ (
measurement range, which have same effect as keys of
5) Press the softkey of Relative (
difference between actual measurement value and current recorded value.
6) Press the softkey of Display (
interface for details.
7) If necessary, press
to description in the chapter of Math operation for details.
Test leads capacitance eliminating method:
1. Plug out the probe end of positive lead out from test circuit, and keep it open.
2. Press Relative to make zero.
ET3260 and ET3260A
) to switch modes, and refer to the chapter of Users
to configure the following measurement parameter, that is gate time,
to configure math operation function (limits and relative), and refer
) and Measurement range- (
) to record the current value, after which display the
) to switch modes, and refer to the chapter of Users
to configure math operation function (limits and relative), and refer
6 1/2 Digit Multimeter
and .
22
) to select fixed