Table of Contents
Advertisement
5 1/2 Digital Mulumeter User Manual
3_ Start the measurement
DIC
®
AIO TRE
0. 57110 v
sense
aw
EUT 4
vase
Figure 4- 19 Measurement interface
Figure 4- 20 Wiring method
4.5.2 On-off measurement
L_In the diode measurement function, p!
*_again to select the on-off measurement. The
measurement interface ís shown mn Figure 4-21
2. Connect the red and black test leads to the corresponding input terminals as shown 1m [Figure
4-22.
3. Start the measurement
sense
meute
an
vom
Figure 4- 21 Measurement interface
Figure 4-22 Wiring method
Note:
1) When the measured resistance 15 greater than 2kO, display "OPEN", less than 2KO, display
readings
2) When the measured value is lower than the set short-circuit resistance value, the buzzer sounds.
The short-circuit resistance value defaults to 300,
3) The short-circuit resistance value can be set by pressing the Enter key in the on-off measurement
interface and using the up, down, left and right direction keys to set between O and 2kO.
4.6 Capacitance measurement
1, Press B e
to select the capacitance measurement function. The measurement interf
shown in ligure 4-23
2. Connect the red and black test leads to the corresponding input terminals as shown in Figure
4-24,
3. Press the up / down arrow key to manually select the appropriate range or select the auto range
|
mode by pressing —
1, press the left / right arrow key to select the appropriate measurement
speed.
4 Start the measurement.
Advertisement
Table of Contents
