Calibration; System Information Inquiry And System Updating; Conduct Remote Control; Gpib Interface Configuration (Only Supported By Et3260) - East Tester ET3260 User Manual

6 1/2 digit multimeter
Table of Contents

Advertisement

Users manual
ET3260 and ET3260A
6 1/2 Digit Multimeter

3.5.5 Calibration

Only qualified professionals can conduct multimeter calibration, and incorrect usage of
calibration function may cause to incorrect multimeter measurement.
Refer to ET3260 and 3260A Calibration Manual for specific calibration details.

3.5.6 System information inquiry and system updating

ET3260 and 3260A support users to update software systems, and in case of users finding system
BUG or needing to add functions, contact after-sales service, and we will serve for system
updating.
Press the key of
(system information) to inquire current system information,
such as serial number and software version number.
Before system updating, it is necessary to make following preparations: contact after-sales
service to gain a needed software update package, prepare a USB drive, establish updatefile
folder under the root directory, copy the software update package to this folder, and plug the
USB driver into the USB interface on multimeter front panel.
Press the key of
(System update) after all the preparations to update the system.

4. Conduct Remote Control

You can conduct remote control to this instrument which supports GPIB, RS232, USB and LAN
interfaces. This chapter introduces how to conduct corresponding configuration. Refer to ET3260
Digit Multimeter Programming Manual for remote interface commands.
To configure interface, press
(Interface) to enter interface setting page.
Press the softkey of
to inquire current LAN information, and re-press
to configure
LAN parameters.
Press the softkey of
to inquire USB information, and there are no configurable options for
USB.
Press the softkey of
to inquire current serial port information, and re-press
to
configure serial port parameters including Baud rate and check digit.
Press the softkey of
to configure GIPB interface address.

4.1 GPIB Interface Configuration (Only Supported By ET3260)

Equipment on GPIB (IEEE-488) interface has to be equipped with an exclusive address. You
37

Advertisement

Table of Contents
loading

This manual is also suitable for:

Et3260a

Table of Contents