Table of Contents
Advertisement
Users manual
ET3260 and ET3260A
6 1/2 Digit Multimeter
off power, the upper limit value will be set as 1 and lower limit value as 0.
In configuration limit test, press
(Limit) to enter setting interface, and edit values
through direction keys.
Press the softkey of Upper limit (
) to set upper limit value.
Press the softkey of Lower limit (
) to set lower limit value.
Press softkye of On/Off (
/
) to start or stop limit operation. After starting, limit test status
indication can be seen in the right side of main interface, with Pass meaning that the measured
value does not exceed the specified upper or lower limit, with Excessively higher meaning
exceed the specified upper limit and Excessively lower meaning exceed the specified lower limit.
When status switches from Pass to Excessively higher or Excessively lower, the beeper will
beep one time.
After setting, press the softkey of Exit (
) to go back to the former-layer interface.
3.3 Trigger
ET3260 and ET3260A provide many trigger methods, including auto, single and external.
Multimeter can read one reading or readings in specified number (up to 50,000) every time it
receives a trigger signal, and can set the delay time between trigger and readings.
In measurement interface, press
to enter the trigger configuration interface indicated in
the following figure.
Press the softkey of Trigger source (
) to set auto, single or external trigger.
32
Advertisement
Table of Contents
