Digital Watchdog VMAX A1 G4 DW-VA1G442T User Manual page 46

Notify
Enable sensor notification via a buzzer sound and/or a pop-up warning.
When "camera pop-up" is enabled, in a multi-screen mode, the system will switch to
NOTE
single-channel mode automatically when the alarm is triggered.
4.3.2. Motion Alarm
Setup the DVR to start recording when motion is detected. The system can also trigger an alarm
signal via the selected sensor-out channel.
On/Off
Turn on or turn off the motion.
Relay
Select related output.
CAUTION
Dwell
Set sensor operation time between 1 second and 15 minutes.
Pre-Alarm
Set the recording period in seconds just before motion is detected. Input up to 5 seconds. The
pre-alarm recording mode is always "continuous" at the recording speed that the user sets
in the "Record" menu.
Motion Area
Set the camera's motion area and sensitivity. The area can be selected by clicking on a
specific block or dragging the mouse's cursor across the screen to select multiple blocks.
Areas where motion detection is activated, will appear with a green borderline. Unselected
areas will be shown with a grey border.
1. Click SET in the MOTION AREA section to set the area.
2. Select the motion detection area and click SAVE and then EXIT to save the changes.
3. Clicking on SELECT ALL will enable motion detection in the entire camera's FoV.
•
Relay contacts can bear up to 24V 1A other devices. If it is connected to
a power of more than 24V 1A, the system may have a problem with it.
User Manual | 42