Battery Replacement For The Remote Control - JVC TH-W513BK Instruction Manual

Battery Replacement for the Remote Control

The remote control requires a CR2032, 3V Lithium battery.
1. Loosen the screw with a screwdriver (not included) and
slide the back cover to open the battery compartment
of the remote control.
2. Remove the old battery.
3. Replace with a new battery.
4. Close the battery compartment cover. Tighten
the screw with a screwdriver (not included).
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause fire,
personal injury or damage to property.
• Install the battery correctly in the battery compartment. Normally the battery's positive polarity (+)
will face up.
• Only use the battery type indicated in this manual.
• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with local
regulations.
• Small button cell batteries such as the one used in the remote control are easily swallowed by young
children and this is dangerous. Keep loose button cells away from young children and make sure that
the battery is secure in the remote control. Seek medical advice if you believe a battery cell has been
swallowed.
Handling the Remote Control
• Take care of your fingernails when you slide and pull the battery release tab.
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as corrosion or
battery leakage may occur and result in physical injury, and / or property damage, and / or fire.
• When the battery is exhausted, the remote control will not function.
GB
9