Programming And Editing Paper Types - Sharp MX-M550 Operation Manual

LOADING PAPER

■ Programming and editing paper types

To program or edit the name of a paper type or set paper attributes, follow the steps below.
1 Touch the [PAPER TYPE REGISTRATION]
key.
OK OK
PAPER TYPE REGISTRATION PAPER TYPE REGISTRATION
Select the paper type that you wish to
2
program or edit.
SYSTEM SETTINGS
OK
PAPER TYPE REGISTRATION
SELECT THE PAPER TYPE TO EDIT.
USER TYPE 1 USER TYPE 2 USER
PAPER TYPE REGISTRATION
USER TYPE 5 USER TYPE 6 USER
Touch the [TYPE NAME] key.
3
A character entry screen appears. Enter up to 14
characters. Refer to page 7-29 for the procedure
for entering characters.
PAPER TYPE REGISTRATION
No.01
TYPE NAME USER TYPE 1
FIXED PAPER SIDE
DISABLE STAPLE
2-16
CANCEL EXIT
DISABLE DUPLEX
DISABLE PUNCH
4 Set the paper attributes.
Touch the checkboxes to the left of the items to
select them.
PAPER TYPE REGISTRATION
No.01
TYPE NAME USER TYPE 1
FIXED PAPER SIDE
DISABLE STAPLE
FIXED PAPER SIDE:
Select this checkbox when paper is to be loaded
print side down in the tray. Make sure a checkmark
does not appear when paper is to be loaded print
side up.
• If the two-sided function is disabled using
"DISABLING OF DUPLEX" in the administrator
settings (page 11 of the administrator settings
guide), load the paper face up.
DISABLE DUPLEX:
Prohibits two-sided printing. Enable when the
backside of the paper cannot be printed on.
DISABLE STAPLE:
Prohibits stapling. Enable when using special
papers such as transparency film and label
sheets.
DISABLE PUNCH:
Prohibits punching. Enable when using special
papers such as transparency film and label
sheets.
NOTES
● Tray attributes depend on the selected paper.
● "FIXED PAPER SIDE" and "DISABLE DUPLEX"
cannot be simultaneously enabled.
5 Touch the [EXIT]
programming/editing procedure.
CANCEL EXIT
DISABLE DUPLEX
DISABLE PUNCH
key to exit the