Sharp MX-M550 Operation Manual page 117

■ Changing the copy settings for each set of originals
When using job build mode, you can change the copy settings each time you place a set of originals.
After performing step 4 on page 5-8, follow the steps below.
5 Touch the [CHANGE] key.
INTERRUPT
ES
ORIGINAL 8 x11 1 /
2
PLACE NEXT ORIGINAL. PRESS [START].
TO CHANGE COPY SETTINGS,
PRESS [CHANGE].
CHANGE READ-END
4.
11x17
6 Select the desired copy settings in the
screen that appears and press the
[START] key.
INTERRUPT
[START].
ORIGINAL
8 x11 1 / READ-END
2
AUTO
EXPOSURE
8 x11 1 /
2
AUTO 8 x11 1 /
2
1. 2.
5. 1 /
8 x11 PAPER SELECT
1 / 1 / 2
8 x11 8 x11
2 2
3.
8 x14 1 /
2
100%
4.
11x17
COPY RATIO
NOTES
● If the original size was set manually at the beginning of the job build procedure, it will not be possible to change
the original size setting. If the automatic original detection function is operating, the original size will be detected
for each set of originals placed.
● When the bypass tray is selected, it is not possible to change the paper type.
● If "XY ZOOM" was initially set for the ratio, it will not be possible to change the ratio setting.
● When job build mode is used in combination with any of the following functions, the [CHANGE] key will not
appear in the screen of step 5.
Pamphlet copy, tandem copy, covers/inserts, transparency inserts, multi-shot, book copy, tab copy, staple sort,
saddle stitch
C
The copy settings that
can be selected are
"EXPOSURE", "PAPER
SELECT", and "COPY
RATIO".
If you touch the [READ-
END] key now, copying
will begin without
scanning the new set of
originals.
7 Touch the [READ-END] key.
INTERRUPT
ES
ORIGINAL 8 x11 1 /
2
PLACE NEXT ORIGINAL. PRESS [START].
TO CHANGE COPY SETTINGS,
PRESS [CHANGE].
CHANGE READ-END
4.
11x17
SPECIAL MODES
C
5-9
5