Interrupting A Copy Run - Sharp MX-M550 Operation Manual

INTERRUPTING A COPY RUN

The copy of the original scanned in interrupt mode is output before the remainder of the interrupted copy job.
1 Touch the [INTERRUPT] key.
INTERRUPT
AUTO
ORIGINA
AUTO
2 3
EXPOSUR
8 x11 1 / 2
AUTO A4
0
CANCEL
AUTO
ORIGINAL A4
EXPOSURE
AUTO 8 x11 1 / 2
PAPER SELECT
100%
COPY RATIO
copy job while the interrupt original is being
scanned or while you are selecting copy settings,
touch the [CANCEL] key.
NOTES
● If you touch the [INTERRUPT] key when auditing
mode is enabled, the display will prompt you to
enter your account number. Enter your account
number with the numeric keys. The copies you
make will be added to the count of the entered
account number.
● If a copy is being printed when the [INTERRUPT]
key is pressed, interrupt mode will begin after the
copy is finished.
● If the copy run to be interrupted is using paper
from the bypass tray, the paper size and type of the
bypass tray cannot be changed for use by the
interrupt job.
● If the document glass is used for an interrupt copy
job, two-sided copying, sort copying, and staple
sort copying cannot be selected. If any of these
functions are necessary, use the document feeder.
5-46
If interrupt copying is
possible during a copy
run, the [INTERRUPT]
key will appear. (If the
key does not appear,
interrupt copying is not
possible.)
When the [INTERRUPT]
key is touched in step 1,
the [INTERRUPT] key
will be replaced by the
[CANCEL] key as shown
in the illustration.
To cancel an interrupt
2 Place the original for the interrupt copy job
in the document feeder or on the
document glass (page 4-3).
3 Select the exposure mode, paper size,
number of copies, and any other copy
settings as needed, and then press the
[START] key.
4 The previous copy job automatically
resumes after the interrupt job finishes.