Safety Notices - Solid State Logic PURE DRIVE OCTO User Manual

Appendices

Safety Notices

General Safety
• Please read and keep this document and adhere to all warnings and instructions.
• This electrical equipment should not be exposed to dust, water, or other liquids.
• Clean only with dry cloth or products compatible with electrical devices and never when the unit is powered.
• Do not operate near any heat sources, in direct sunlight or near naked flames.
• Do not place heavy objects on the unit.
• Only use attachments/accessories recommended by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Do NOT modify this unit, alterations may affect performance, safety and/or international compliance standards.
• The unit can only be serviced by qualified personnel – seek immediate service if the console has been exposed to water or
if it ceases to operate normally.
• SSL does not accept liability for damage caused by maintenance, repair or modification by unauthorised personnel.
• When using this apparatus either fix it into a standard 19" rack or place it on a secure level surface.
• If the unit is rack mounted, fit all rack screws. Rack shelves are recommended.
• Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
• Always allow free flow of air around the unit for cooling.
• Ensure that no strain is placed on any cables connected to this apparatus. Ensure that all such cables are not placed where
they can be stepped on, pulled or tripped over.
Power Safety
• This equipment is supplied with mains lead however if you wish to use a mains cables of your choice refer to the following
information:
• Refer to the rating label on rear of the unit and always use a suitable mains cord.
• The unit should ALWAYS be earthed.
• Please use-compliant 60320 C13 TYPE SOCKET. When connecting to supply outlets ensure that appropriate sized conductors
and plugs are used to suit local electrical requirements.
• Maximum cord length should be 4.5m(15').
• The cord should bear the approval mark of the country in which it is to be used.
Additionally:
• The appliance coupler is used as the disconnect device, ensure that it is connected to an unobstructed wall outlet.
• Connect only to an AC power source that contains a protective earthing (PE) conductor.
• Only connect units to single phase supplies with the neutral conductor at earth potential.
32
ATTENTION! This product must always be earthed.
CAUTION! No user-serviceable parts inside. In the event of damage to the unit contact Solid State Logic.
Service or repair must be done by qualified service personnel only.
PURE DRIVE OCTO User Guide