Table of Contents
Advertisement
The system will display code notifications as required. See troubleshooting section for additional information.
In the top right of the display are other system information icons.
Communicating on any interface (e.g., Bluetooth, VE.Can,
etc.)
Bluetooth Enabled, Icon colour changes when connected
MPPT Active
(Blinking) Error or Warning
Battery, fill corresponds with voltage, blinks when empty
4.3. STATUS - Live Data Information
• MPPT [Model Number] confirms the connected device. A custom name can also be set if desired.
• Solar 'Gauge' icon shows the dynamic real-time power output from the solar array. With regard to the Solar Panel voltage,
note that the Solar charger will only operate once the Panel voltage has risen more than 5V above battery voltage.
• Battery - Voltage The voltage measurement is taken at the battery terminals of the Solar charger.
• Battery - Current This reading shows the current flowing-to, or drawn-from the battery terminals of the Solar charger. Note that
in the case of the 100/20 Solar chargers and smaller - which have a dedicated load output - a Positive notation alongside the
current reading means that current is flowing to the battery; whereas a Negative notation means that current is being drawn
from the battery.
• Battery - State:
• Bulk: During this stage the Controller delivers as much charge current as possible to rapidly charge the batteries. When the
battery voltage reaches the Absorption voltage setting, the Controller activates the Absorption stage.
• Absorption: During this stage the Controller switches to the constant voltage mode, where a pre-set absorption voltage,
suitable to the battery type (See section 4.1 Battery Settings below), is applied. When the charge current decreases below
Page 18
www.butlertechnik.com
Isolated SmartSolar MPPT RS
www.butlertechnik.com
Operation
Advertisement
Table of Contents
