Advertisement
Feed Handles/Bars
1. Thread the Feed Handle Bars (27) into the
Feed Bar Seat (44) and tighten them.
2. Thread the Feed Handle Knobs (26) onto
the Feed Handle Bars and tighten them.
Installing/Removing the chuck
1. Loosen the Lock Handle and slide the
Table up the Column to within 6" of the
Spindle (71). Tighten the Lock Handle.
2. Open the jaws of the Chuck (76) to their
maximum, using the supplied Chuck Key.
3. Put a piece of scrap wood on the
table to protect the Chuck nose.
4. Ensuring all parts are thoroughly clean, dry and
burr free, place the Chuck with its open jaws on
the scrap wood, directly under the Spindle.
5. Use the Feed Handle to gently lower the
Spindle so it is just entering the opening
in the top of the Chuck.
6. Examine the Chuck from all sides to be sure
that it is properly aligned with the Spindle.
7. Using the Feed Handles, insert the Spindle all
the way into the Chuck, pressing the Chuck
nose hard against the piece of scrap wood on
the Table to secure the Chuck into place.
Page 8
For technical questions, please call 1-888-866-5797.
Feed Bar
Seat (44)
Feed
Handle
Bar (27)
chuck (76)
Table
Feed Handle
Knob (26)
Item 58782
Advertisement
