Advertisement
4. While holding Gear Rack and Table
Support as assembled, slide both down
onto the Column until Gear Rack bottom
is positioned against Column Base.
5. Replace Rack Collar, beveled side down, onto
Column and top of Gear Rack. Tighten Set Screw.
Note: Ensure that Gear Rack is not
pinched. Gear Rack should move freely
when Table is rotated around Column.
6. Assemble the Lift Handle (85) to the
end of the Worm Gear shaft and secure
it in place with the Set Screw.
Note: Confirm the Set Screw engages the
flat surface of the Worm Gear shaft.
Head Assembly to column
1. Loosen the Set Screw (32) on each side of the Head
Assembly so they will stay clear while installing it.
2. With assistance, lift the Head Assembly above
the Column, and gently slide it down the
Column as far as it will go. Make sure the Head
Assembly slides completely onto the Column.
3. Align the Head Assembly with the Base,
and tighten the two Set Screws to secure
the Head Assembly in place.
Item 58782
For technical questions, please call 1-888-866-5797.
Set Screw (9)
Set Screw (9)
column (101)
Set Screw
(32)
Rack
collar (78)
Lift
Handle (85)
Gear
Rack (92)
column
Base (93)
Head
Assembly
Page 7
Advertisement
