Table of Contents
Advertisement
Ceramic, wooden, or glass countertop
Given the margin of error (tolerance) for the glass ceramic plate of the appliance, and the cut-out
in the countertop, the slot is adjustable (min. 2mm).
Install the wooden frame 5 mm below the upper edge of the countertop (see figure).
Observe the radii of glass edges (R10, R2) when making the cut-out.
Removing the built-in appliance
Disconnect the induction hob from the power mains. Use a suitable tool to remove the silicone gasket
from the perimeter. Remove the induction hobby pressing from the lower side upwards.
WARNING!
Do not attempt to remove the appliance from the upper side of countertop.
WARNING!
The service department shall only be responsible for repair and servicing of the induction hob.
Consult your specialized kitchen equipment dealer regarding the re-installation of the flush-mount
induction hob.
WARNING!
If the oven is installed under a flush-mounted induction hob, then the worktop thickness should
be at least 45 mm.
12
GLASS
1. Countertop
2. Appliance
3. Slot
4. Wooden frame, thickness
16 mm.
CUT-OUT
Advertisement
Table of Contents
