Sanyo DSR-2016 Instruction Manual page 41

L I V E s e t t i n g s
● Setting the SEQUENCE
Sets whether the output video automatically switches to the
MON2 terminal.
1
Select "SEQUENCE" using the control button ({|).
2
Set ON/OFF using the control button (}~).
ON: Automatically switches
OFF: Does not automatically switch
3
Press the ENTER button.
● Setting the SEQUENCE-DWELL TIME
If "SEQUENCE" is set to ON, set the switching interval.
1
Select "SEQUENCE-DWELL TIME" using the control
button ({|).
2
Set the switching interval (1 - 10 seconds) using the
control button (}~).
3
Press the ENTER button.
● Setting the MON2 CHANNEL
Sets the channel that outputs the video to MON2 terminal.
<If "SEQUENCE" is set to OFF>
1
Select "MON2 CHANNEL" using the control button ({|).
2
Select the setting position using the control button (}~).
If "MON2 TYPE" is set to "FULL" set one channel if it is set
to "QUAD" set 4 channels.
3
Select a channel (1 - 16) using the control button
({|}~).
4
Move the cursor back to "MON2 CHANNEL" using the
control button (}~).
<If "SEQUENCE" is set to ON>
1
Select "MON2 CHANNEL" using the control button ({|).
2
Select a channel using the control button ({|).
The factory default display hides the channel numbers.
3
To select ON or OFF for the automatic switch display
(channel number display) press the ENTER button.
MON2-OUT
MON2 TYPE
MON2 ON EVENT
MON2 EVENT DWELL TIME
SEQUENCE
SEQUENCE-DWELL TIME
MON2 CHANNEL
4
Move the cursor back to "MON2 CHANNEL" using the
control button ({|}~).
FULL
ON
10 SEC
ON
10 SEC
1 2 3 4
5 6 7 8
- - - -
- - - -
34