Exiting The System Configuration Utility - Epson ActionNote 650 User Manual

Power management options [continued)
Option
Defaults menu
Exit menu
* Default setting
(1) To enable an Alarm Resume time, press Enter and then press
you see Enabled. Then press Enter again and use the arrow keys to select
a resume time in hours and minutes. Press Enter again to return to the
pull-down menu.
(2) If you enabled Auto Suspend and Video Monitoring, you should not
use any Windows screen saver programs because the screen saver may
prevent your computer from entering suspend mode.
(3) If you enable Video Monitoring and your system's video is active, the
system does not enter any standby or suspend modes. If you disable
Video Monitoring the system ignores video activity (such as a blinking
cursor) and enters these modes as necessary.
Existing the System Configuration Utility
When you are ready to exit the SCU, press E
Exit menu bar option. If you have not changed any settings,
you see a message telling you to press E
If you have changed any settings, you see a screen offering two
exit options:
Esc
Enter
1-18
Setting Up the Computer
Description
Sets all the power management options to their
default values
Allows you to save your settings and exit the Power
Management Screen (if you changed settings) or exit
without saving your settings; returns to SCU, MS-DOS
prompt, or Windows, depending on how you brought
up the Power Management screen
Returns you to the SCU screen; press E
again to exit the SCU without saving any
changes and reboot the computer
Saves your settings and reboots the
computer.
Settings
or
or select the
SC
to exit the SCU.
SC
until
S C