Water Level - Energetics WR 1100 Manual

HOW TO FILL AND EMPTY THE TANK
1. Remove the Fill Plug (No.50) from the Upper Tank Cover (No. 24).
2. To fill the tank with water, refer to Fig. A. Insert the Funnel (No. 52) into the tank, then
use a cup or the Siphon Pump (No. 53) and a bucket to fill the tank. Use the water level
gauge on the side of the tank to measure desired water level in the tank.
3. To empty the tank, refer to Fig. B. Place a bucket next to the rower, and use the Siphon
Pump (No. 53) to pump out the water from the tank into the bucket.
4. Insert Fill Plug (No. 50) into the Upper Tank Cover (No. 24). Wipe excess water off of the
frame.
NOTE
•
Fill the tank only with tap water. Add 1 water-purification tablet (1 packet is included.).
Never use pool chlorine or chlorine bleach. This will damage the tank and void the
warranty.
•
Add a water purification tablet every 6 months or as needed. If water remains cloudy,
replace the water in the tank.
•
Do not consume the tank water. Dispose the water after pumping it out from the tank.

WATER LEVEL

•
See Fig. A. The water level gauge is on the side of the tank. The maximum fill level is
6. Never fill it over this limit. Filling the tank over this limit will void the warranty.
•
The resistance depends on the water level in the tank. Water level 1 is for the lowest
resistance. Level 6 is for the highest resistance.
11