Dahua DHI-NVR5224-24P-4KS2 User Manual page 157


Default gateway: Here you can input the default gateway. Please note system needs to
check the validity of all IPv6 addresses. The IP address and the default gateway shall be in
the same IP section. That is to say, the specified length of the subnet prefix shall have the
same string.

DHCP: It is to auto search IP. When enable DHCP function, you cannot modify IP/Subnet
mask /Gateway. These values are from DHCP function. If you have not enabled DHCP
function, IP/Subnet mask/Gateway display as zero. You need to disable DHCP function to
view current IP information.
IP/Subnet mask /Gateway.

MTU: It is to set MTU value of the network adapter. The value ranges from 1280-7200 bytes.
The default setup is 1500 bytes.

Transfer mode: Here you can select the priority between fluency/video qualities.
Step 4 Click OK to NIC settings.
Device goes back to TCP/IP interface.
Note
Click to cancel NIC bonding. Please note device needs to reboot to activate new setup.
Step 5 Set network parameters.

IP Version: There are two options: IPv4 and IPv6. Right now, system supports these two IP
address format and you can access via them.

Preferred DNS server: DNS server IP address.

Alternate DNS server: DNS server alternate address.

Default Network Card: Please select eth0/eth1/bond0(optional) after enable multiple-access
function.

LAN download: System can process the downloaded data first if you enable this function.
The download speed is 1.5X or 2.0X of the normal speed.
Note

For IPv6 version, the IP address, default gateway, preferred DNS; alternate DNS is
128-digit. Please fill in all items here.

This function is for some series product only.
Step 6 Click Next to complete the settings.
4.1.4.3 P2P
Click Next button, you can set P2P function. Scan the QR code, download the App to the cell phone, you
can use the smart phone to add the device.

Scan the QR code on the actual interface to download the cell phone app. Register an account and
then use.

Go to the www.easy4ip.com to register an account and use the SN to add a device. Refer to the P2P
operation manual for detailed information.
Warning
Before use the P2P function, make sure the NVR has connected to the WAN.
Besides, when PPPoE is operating, you cannot modify
145