Dahua DHI-NVR5224-24P-4KS2 User Manual page 152

Here you can set device time. You can enable NTP (Network Time Protocol) function so that the device
can sync time with the NTP server.
Step 1 Click Date and time button. See Figure 4-12.
Note
From Main menu->Setting->System->General->Date and time, you can go to the date and
time interface.

System time: Here is for you to set system time

Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or DD-MM-YYYY.

Date separator: There are three denotations to separate date: dot, beeline and solidus.

DST: Here you can set DST time and date by week or by date. Please enable DST function
and then select setup mode. Please input start time and end time and click Save button.

Time format: There are two types: 24-hour mode or 12-hour mode.

NTP: It is to set NTP server, port and interval.

System time is very important; do not modify time casually unless there is a must!

Before your time modification, please stop record operation first!
Step 5 Click Apply button to save settings.
4.1.4.1.3 Holiday
Warning
Figure 4-12
140