Table of Contents
Advertisement
5-3
Processor and Heatsink Installation
When handling the processor, avoid touching the gold contacts. Also, do not place
the serverboard on a conductive surface, which can damage the BIOS battery and
prevent the system from booting up.
Notes:
•
Always connect the power cord last and always remove it before adding, re-
moving or changing any hardware components. Make sure that you install the
processor into the CPU socket before you install the CPU heatsink.
•
If you buy a CPU separately, make sure that you use an AMD-certified multi-
directional heatsink only.
•
Make sure to install the serverboard into the chassis before you install the
CPU heatsinks.
•
When receiving a serverboard without a processor pre-installed, make sure
that the plastic CPU socket cap is in place and none of the socket pins are
bent; otherwise, contact your retailer immediately.
•
Refer to the Supermicro web site for updates on CPU support.
Installing the Processors
1. Begin by removing the cover plate that
protects the CPU. Lift the lever on the
CPU socket until it points straight up.
2. With the lever raised, lift open the silver
CPU retention plate.
Chapter 4: System Safety
5-3
Advertisement
Table of Contents
