Supero 1122GG-TF User Manual page 105

disk drive support. Select "Disabled" to prevent AMI BIOS from using the
S.M.A.R.T. Select "Enabled" to allow AMI BIOS to use the S.M.A.R.T. to sup-
port hard drive disk. The options are Disabled, Enabled, and Auto.
32-Bit Data Transfer
Select "Enabled" to activate the function of 32-Bit data transfer. Select "Dis-
abled" to deactivate the function. The options are Enabled and Disabled.
Hard Disk Write Protect
Use this setting to Enable or Disable hard disk write protection for your system.
This is effective only if the device is accessed through the BIOS.
IDE Detect Timeout (Sec)
Use the +/- keys to adjust and select the time out for detecting ATA/ATAPI
devices. The default value is 35.
ATA(PI) 80Pin Cable Detection
This option selects the mechanism used for detecting the installation of an 80-pin
ATA(PI) cable. Options include Host & Device, Host or Device.
 PCI/PnP Configuration
Clear NVRAM
Select Yes to clear NVRAM during boot-up. The options are Yes and No.
Plug & Play O/S
Select Yes to allow the OS to configure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No
to allow AMIBIOS to configure all devices in the system.
PCI Latency Timer
This option sets the latency of all PCI devices on the PCI bus. Select a value
to set the PCI latency in PCI clock cycles. Options are 32, 64, 96, 128, 160,
192, 224 and 248.
Allocate IRQ to PCI VGA
Use this option to allocate IRQ to the PCI VGA card. Opiton include Yes and No.
Selecting Yes assigns IRQ to PCI VGA card if the card requests IRQ. Selecting
No means the system will not assign IRQ to the PCI VGA card even if the card
requests IRQ.
7-13
Chapter 7: BIOS