Everlast PowerMTS 400 Operator's Manual page 19

POLARITY FOR STICK/MMA
NOTE: Some electrodes are able to be
run with electrode negative polarity,
but this is typical configuration of
most all rods. Some specialty rods
may only be run electrode negative.
Check with electrode manufacturer.
STICK ELECTRODE HOLDER
POLARITY FOR TIG
NOTE: TIG torch connects direct to the
regulator. Fittings to connect TIG torch
directly to the Regulator are not included.
Customer should purchase fittings sepa-
rately at time of purchase, or source
locally. Some adaptation of the gas fitting
may be required.
TO REGULATOR
WORK
WORK CLAMP
Setup Guide
Getting Started
WORK
WORK CLAMP
GAS VALVE TIG TORCH
POLARITY FOR CARBON ARC GOUGING
NOTE: Carbon arc gouging torch, and
necessary connections are supplied by
customer. It is not sold by Everlast.
TO AIR COMPRESSOR
CARBON ARC TORCH
Do not leave MIG/Wire Feed gun connected while welding other pro-
cesses and remove all torches and accessories while welding wire feed
processes. Disconnect all fittings and connections relating to the other
welding processes. The power source terminals remain live while weld-
ing other processes. This can lead to accidental arcing and damage to
the components and machine. It can also lead to accidental arc flashing
of the eyes and burns, shock and injuries to the body. Damage done to
the welder from leaving the other accessories and torches connected
while welding that are not required for use with the selected process
will not be covered under warranty!
19
WORK
WORK CLAMP
WARNING!