V1-6 Above Deck Fi Tting - Lewmar V1/Sport Owner's Manual

3. Installation
3.7 V1-6 above deck fi tting
1. Using your template and after you
have checked all the above and
below deck requirements cut the
following holes.
• Model V1-3
3
Using a 10 mm ( / ") diameter drill,
8
make the fi ve holes for the mounting
studs and sensor. With a 75 mm (3")
diameter hole saw, make two holes
for the rode and down tube to pass
through.
• Models V4-6
7
Using a 12 mm ( / ") diameter drill,
16
make the fi ve holes for the mounting
studs and sensor. With a 115 mm
(4 1 / ") diameter hole saw, make two
2
holes for the rode and down tube to
pass through.
2. When all the holes have been made,
remove the template. To help avoid
water absorption by the deck, apply
an appropriate marine sealant to the
freshly cut hole edges.
3. Assemble and tighten studs into
base until they bottom out in their
holes. Some studs have a fl at.
Position the fl ats of the studs
nearest the base of the windlass.
3.7-1 3.7-2 3.7-3
Lewmar V1-6 & SPORT Windlass | 11