Table of Contents
Advertisement
Troubles shooting
Verify that is using the right power cord/adapter (DC 12-48V), please don't
use the power adapter with DC output bigger than 48V, or it will burn this
switch down.
Select the proper UTP cable to construct your network. Please check that
you are using the right cable. use unshielded twisted-pair (UTP) or shield
twisted-pair ( STP ) cable for RJ-45 connections: 100Ω Category 3, 4 or 5
cable for 10Mbps connections or 100Ω Category 5 cable for 100Mbps
connections. Also be sure that the length of any twisted-pair connection
does not exceed 100 meters (328 feet).
Diagnosing LED Indicators: the Switch can be easily monitored through
panel indicators to assist in identifying problems, which describes common
problems user might encounter and where user can find possible solutions.
If the power indicator does turn on when the power cord is plugged in, it
might have a problem with power cord. Than check for loose power
connections, power losses or surges at power outlet. IF you still cannot
resolve the problem, contact the local dealer for assistance.
If the Industrial switch LED indicators are normal and the connected cables
are correct but the packets still cannot transmit. Please check the system's
Ethernet devices' configuration or status.
59
Advertisement
Table of Contents
