Troubles Shooting - Lantech IGS-2206C User Manual

Troubles shooting

 Verify that is using the right power cord/adapter (DC 9-56V), please don't use the
power adapter with DC output higher than 56V, or it will burn this converter down.

Select the proper UTP cable to construct user network. Please check that is using
the right cable. use unshielded twisted-pair (UTP) or shield twisted-pair (STP) cable
for RJ-45 connections: 100Ω Category 3, 4 or 5 cable for 10Mbps connections, 100
Ω Category 5 cable for 100Mbps connections, or 100Ω Category 5e/6 cable for
1000Mbps connections. Also be sure that the length of any twisted-pair connection
does not exceed 100 meters (328 feet).

Diagnosing LED Indicators: The Switch can be easily monitored through panel
indicators, which describes common problems user may encounter and where user
can find possible solutions, to assist in identifying problems.

If the power indicator does not light on when the power cord is plugged in, user may
have a problem with power cord. Then check for loose power connections, power
losses or surges at power outlet. If user still cannot resolve the problem, contact
user local dealer for assistance.

If the Industrial switch LED indicators are normal and the connected cables are
correct but the packets still cannot transmit. Please check user system's Ethernet
devices' configuration or status.
106