Table of Contents
Advertisement
Insert the stopper on the under-
2.
side.
Clean the filter in the condensation
3.
container.
18.2 Calling up the appliance
care programme
Requirement: The appliance care
programme is ready.
→ "Preparing for appliance care",
Page 48
Press
.
1.
The switch-on process takes a few
seconds.
Press and hold Basic Settings 3
2.
sec. for approx. 3 seconds.
Press the required cleaning pro-
3.
gramme:
Basic appliance care pro-
‒
gramme
Intensive appliance care pro-
‒
gramme
18.3 Running the basic appli-
ance care programme
To remove any dirt deposits in the
appliance, you can run the basic ap-
pliance care programme.
Notes
The basic appliance care pro-
¡
gramme runs for approximately
1 hour.
After a lengthy period of use, the
¡
appliance reminds you to run the
basic appliance care programme.
Before the programme starts or
after the programme has ended,
the display shows the message "
Basic machine care re-
quired" . This message appears re-
peatedly until you have run the ba-
sic appliance care programme
through to the end.
Requirements
The appliance care programme is
¡
ready.
→ "Preparing for appliance care",
Page 48
The simple appliance care pro-
¡
gramme is now called up.
→ "Calling up the appliance care
programme", Page 49
Pour approx. 1.5 litres of hot tap
1.
water into the condensation con-
tainer.
Hold the filled condensation con-
tainer level so that no liquid spills
out.
Insert the condensation container
2.
so that it locks into place.
Press Start/Reload .
3.
The appliance care programme
a
starts and a signal tone sounds.
"Finished, remove washing " ap-
a
pears on the display and a signal
tone sounds once the appliance
care programme has ended.
Pull out the condensation con-
4.
tainer horizontally and empty it.
→ "Emptying the condensation
container", Page 38
If you are draining the condensa-
5.
tion water using the drain hose:
Remove the stopper from the
‒
underside of the condensation
container.
Appliance care en
49
Advertisement
Table of Contents
