Cd-Rom And Floppy Drive Installation - Supero AS-1010S-T User Manual

AS1010S-T User's Manual
Serial ATA Backplane
The Serial ATA drives plug into a backplane that provides power, drive ID and bus
termination. A RAID controller can be used with the backplane to provide data
security. The operating system you use must have RAID support to enable the hot-
swap capability of the Serial ATA drives. The backplane has the following jumpers
you need to be aware of:
JP18: Alarm Reset (high temperature alarm)
JP25: Hard drive threshold temperature (when exceeded, alarm will sound)
Settings: Open = 45º C, Pins 1-2 = 50º C, Pins 2-3 = 55º C

CD-ROM and Floppy Drive Installation

The top cover of the chassis must be opened to gain full access to both drives. The
CD-ROM drive must have a "slim" profi le to fi t into the 1010S-T. You must power
down the system before installing or removing a CD-ROM or fl oppy drive.
First, grasp the two handles on either side and pull the unit straight out until it locks
(you will hear a "click"). Next, depress the two buttons on the top of the chassis
to release the top cover and at the same time, push the cover away from you until
it stops. You can then lift the top cover from the chassis to gain full access to the
inside of the server.
To install either type of drive, start by disconnecting the drives' power and data
cables then remove the two screws from either side of the bracket the secures the
drives to the chassis. With these screws removed, you can then lift out the entire
assembly (drives and bracket). Both the CD-ROM and the fl oppy drives are each
secured to this bracket with four screws (two on either side). Remove these screws
to take out the drive then install a new drive into the same space. Secure it to the
bracket with the four screws. Then place the assembly back into place and secure
it to the chassis with the two screws previously removed. Finish by reconnecting
the drves' power and data cables.
Drives mount on rails and should "click" into place to be correctly and fully installed
in their bays.
• A red mark on a wire typically designates the location of pin 1.
6-6