Adding Pci Cards - Supero AS-1010S-T User Manual

Chapter 5: Advanced Motherboard Setup
5-7

Adding PCI Cards

1. PCI slots:
The H8SSL-i has three PCI expansion slots. One of these slots (the 133 MHz PCI-
X slot #6) may be populated with the use of the CSE-RR1U-X riser card, which is
included with the system. You may install either a 133 or a 100 MHz PCI-X card
into the riser card.
2. PCI card installation:
Before installing a PCI add-on card, make sure it is supported by the riser card (see
step 1, above). Begin by pulling the locking tab downward to unlock the bracket
that covers the slot, then remove the bracket. Insert the PCI card into the riser
card, pushing down with your thumbs evenly on both sides of the card. When the
card is correctly installed, fi nish by pushing the locking tab upward to secure the
card in the system.
Note: the PCI slot shield helps promote proper airlow in the chassis and shield the
inside of the system from EMI (electromagnetic interference). For these reasons,
make sure there is a shield covering the slot if unused.
5-9