Wacker Neuson BS-2 Operator's Manual page 20

Safety
4.10 Maintenance
4.10.1.1 Threaded fittings
4.10.2 Vehicle fluids
20
All threaded fittings must comply with the specified specifications and be
firmly bolted together. Observe the tightening torques! Screws and nuts
must not be damaged, bent or deformed.
Particular attention should be paid to the following:
• Self-locking nuts and micro-encapsulated screws must not be reused
after loosening. The fastening effect is lost.
• Threaded fittings with adhesive protection/liquid adhesives (e.g. Loc-
tite) must be cleaned after loosening and provided with new adhes-
ive.
Information
Observe the instructions of the liquid adhesive manufacturer.
• Always wear protective goggles and gloves when handling vehicle
fluids. Seek medical advice immediately if, for example, hydraulic oil,
fuel, oil or coolant gets into the eyes.
• Avoid direct skin contact with vehicle fluids. Wash skin immediately
with soap and water.
• Do not eat or drink while working with vehicle fluids.
• Contaminated vehicle fluid (e.g. with dirt, water) can lead to prema-
ture wear or failure of the machine.
• Dispose of discharged or spilled vehicle fuel in accordance with ap-
plicable environmental regulations.
• If vehicle fluids leak from the machine, stop operating the machine
and have it repaired immediately by a service partner.
Operator's Manual | BS-2 | 5100056271 | 07/2022 | [en]