Table of Contents
Advertisement
s
Sampling time (
NOTE !
Is the parameter
tinuous process is detected. At the parameter
the time "auto" is displayed.
The configuration of the Normal Display Mode (
temperature value is saved during sampling
Display mode (
As an option, the green Status LED can light up or the digital output can
be used to indicate sampling.
When the sampling time has ended, an average value is calculated for
recorded measuring cycles. The temperature reading is weighted with
the previously saved average value and added.
Weighted average
F-PR
(
)
The smaller you set the
be.
When the averaging function is activated (
check will be performed. The difference in temperature between the cur-
rent reading and the previously stored average is established. If the dif-
ference is higher than the plausibility threshold
data will be „0" and the average value will remain unchanged.
Plausibility (
TSP_
Plausibility (
TSP~
T.ACT
) During the sampling time the temperature is
detected and stored as a temperature val-
ue.
T.ACT
= 0 automatically the end of the discon-
ANO
„t=0" displays the lower temperature range
)
limit during the measurement. „
dicates the previous temperature reading
during the current measurement.
Factor for average weighting. If you choose
100%, averaging will be off.
F-PR
)
Threshold for plausiblity check: lower limit
which is acceptable for a valid measure-
ment.
)
Threshold for plausiblity check: upper limit
which is acceptable for a valid measure-
ment.
Operating Manual MPA
ANO
factor, the stronger the weighting will
F-PR
TSP
20
T.ACT
instead of
) determines which
T.HLD
" in-
<100%) a plausibility
, the transmitted
Advertisement
Table of Contents
